1. Create an account to join in the discussion. Once you register don't forget to enter our monthly drawings.

    Register to post on our forum.
  2. Home Theater Lounge will begin holding a live chat every Wednesday evening at 9pm Central. The goal is to get as many members online at the same time and just talk movies, music, and gear. You can join the chat by going to the Shoutbox app.
    Dismiss Notice
  3. Dismiss Notice

New Sub Driver SDX15

Discussion in 'DIY Lounge' started by E Jones, May 12, 2007.

  1. E Jones

    E Jones Active Member

    I was just checking out CSS and noticed this on their front page:
    http://creativesound.ca/

    SDX 15"

    This is the first high excursion Subduction driver using a 3" XBL2TM motor with dual 2 ohm voice coils.

    - fiberglass/nomex woven cone with foam surround

    - high power, low inductance design, 4 layer 3" copper voice coil and copper shorting ring inside the magnet

    - forged and machined T-yoke and top plate with larger radiused pole vent for low aerodynamic noise

    - high excursion spider with integrated lead wire

    - attractive cast aluminum basket design with cast aluminum trim ring

    - long Xmax and a "bottomless" basket design

    Specs say 30mm xmax... not bad for $270

    -EJ
     

Share This Page